[j-nsp] Juniper M7i, Junos9.2 w/ PE-1GE-SX-B , 802.1Q inter vlan routing

[Mustafa Golam -]

Hi Samit,
Configure the link as Layer two trunk and allow relevant VLAN.
You are done.
Start with:
http://www.juniper.net/techpubs/software/erx/junose52/swconfig-physical/html/ethernet-config8.html#274361

HTH,
Mustafa


On Tue, Oct 21, 2008 at 11:31 AM, Samit <janasamit at wlink.com.np> wrote:
> Hi,
>
> I am quite elated that we are now moving into Juniper from Cisco
> (Npe-g1) for our border gateway deployment w/ 2 full bgp feed.
>
> We are getting couple of used M7i with Junos 9.2 w/ PE-1GE-SX-B next
> week. I have a very simple question....due to lack of junos knowledge,
> The M7i Gig interface will be connected with Catalyst 3400 802.1Q trunk
> port and I need to do a intervlan routing from M7i box . How do I do it,
> any config tips will be appreciated.
>
> Regards,
> Samit
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>



-- 
--
*´¨)
¸.•´¸.•*´¨) ¸.•*¨)
(¸.•´ (¸.•` *Mustafa Golam
Fedora Ambassador, Bangladesh
-.*.-`,`.*RHCE,CC{D,I,N,V..}P`.CCIE(..)'.'`,.
http://fedoraproject.org/wiki/MustafaGolam
http://mustafa.golam.googlepages.com/home
"Winners never quit------Quiters never win"