[j-nsp] monitor interface rate

[harbor235]

Do you know ho wit does it? I am using HP OpenView, cannot change that. ;{

mike

On Thu, Aug 13, 2009 at 9:26 AM, Bit Gossip <bit.gossip at chello.nl> wrote:

> cacti (http://cacti.net/) does it out-of-the box...
>
>
> On Thu, 2009-08-13 at 09:06 -0400, harbor235 wrote:
> > To all,
> >
> > I would like to monitor a juniper router interface via snmp, simple
> enough.
> > However, I do not want bps, I want to monitor the interface as a
> percentage
> > of it's total capacity. In the end I want to be notified if my interface
> > exceeds 70%
> > of capacity so I can initiate capacity management planning.
> >
> > I know I can on an interface by interface basis figure out 70% and
> program
> > that into
> > each interface collection, however, that does not scale. Is there anyone
> out
> > there
> > that knows of a MIB obect that does this?
> >
> > thanx,
> >
> > Mike
> > _______________________________________________
> > juniper-nsp mailing list juniper-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/juniper-nsp
>
>