[j-nsp] M7i Hard Disk Replacement

Jonas Frey jf at probe-networks.de
Fri Aug 14 12:50:17 EDT 2009


I recommend using SSD's, see:

http://juniper.cluepon.net/index.php/Replacing_the_harddisk_with_solid_state_flash

Regards,
Jonas

> >> Hello,
> >>
> >> I was wondering if anyone has successfully replaced a hard disk on a M7i
> >> RE-5.0. If so with what model disk, and once installed what is the procedure
> >> to get the disk back to working/formatted condition.
> > 
> > No magic involved. Just replace it with a disk of the same or greater
> > capacity. Be sure it's one rated for continuous operation, not a
> > standard laptop drive. (This will make the drive a lot more expensive!)
> > 
> > 
> > Then just "request system snapshot partition" for format, partition, load
> > the drive.
> 
> Make sure the jumper on the drive is set to "slave" mode.
> 
> - Kevin
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp




More information about the juniper-nsp mailing list