[j-nsp] SNMP polling a logical-system without encoding it asLS/RI at community

Subodh Kumar subodh at juniper.net
Thu Jan 15 11:19:30 EST 2009


> > One question though: I see that you mention ri2, which is different
> > from the default routing instance. Does that actually matter? So far
> > we have not been using routing instances, but do you think we
> > actually need to setup one explicitly, within the logical-system?

No, it doesn't matter. Instead of "lr1/ri1" used in my config, in your
case you can use "mytarget/default".

> 
> One more question:
> 
> In your configuration I see only physical interfaces. To the extent of
> your knowledge, does it matter if the entry point is a logical sub-
> interface (unit) assigned to lr1, while the physical interface is used
> by R1?

Again, I don't think this should cause any problem.


Thanks
Subodh




More information about the juniper-nsp mailing list