[j-nsp] ERX 1400 cCOC 12 / OC3 line card issue

[Bernd Goldschmidt]

Hi Rocco,

please check the module guide:
http://www.juniper.net/techpubs/hardware/erx/junose101/hw-erx-module/hw-
erx-module-TOC.html
IOA should be labeled like: "cOC3 STM1 F0 I/O" as the channelized
linecards requires a special IOA (show hardware list it as e.g.
"COC3-4SM-IR I/O").

The 350-10065-02 will only work with ATM and POS linecards.

Gruss
Bernd.

                            serial      assembly    assembly   ram
slot         type           number       number       rev.     (MB)
----   ----------------   ----------   ----------   --------   ----
x      COC3/COC12         xxxxxxxxxx   3500009800     A04      128
                                                               number
                                                                 of
                           serial      assembly    assembly      MAC
slot        type           number       number       rev.     addresses
----   ---------------   ----------   ----------   --------   ---------
x      COC3-4SM-IR I/O   xxxxxxxxxx   3501010700     A04



> -----Original Message-----
> From: juniper-nsp-bounces at puck.nether.net 
> [mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of Dr 
> Rocco DiSanto
> Sent: Saturday, June 06, 2009 22:25 PM
> To: juniper-nsp at puck.nether.net
> Subject: [j-nsp] ERX 1400 cCOC 12 / OC3 line card issue
> 
> 
> Hi All,
> 
> I'm attempting to bring up an oOCx-STMx F0 line card 
> (350-00098-00) on a
> legacy ERX 1400. 
> I am using a PIC OC3-4SM_I/O card (350-10065-02) OC3 with 4 SM ports. 
> Can someone tell me if this is a valid hardware configuration? 
> I receive a message at boot "ERROR Line Card in slot 8 
> autoboot disabled"
> and the line card never boots. 
> 
> Any guidance would be much appreciated.
> 
> Rocco 
> 
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>