[j-nsp] EX-4200 VC, unable to lock config on fpc

[Nitzan Tzelniker]

Hi

do you have firewall filter on lo0 ?
I see similar issue when I did it

Thanks

Nitzan

On Wed, Jun 24, 2009 at 04:41, Ross Vandegrift <ross at kallisti.us> wrote:

> On Tue, Jun 23, 2009 at 05:30:38PM -0700, Cord MacLeod wrote:
> > I had this issue adding members to an existing VC.  Did you upgrade all
> > of the members to the same code?  When I did, the issue was fixed.
>
> You run VC with mis-matched code versions?  You are braver than I!  We
> always run the same code on all members and upgraded the entire VC at
> the time of upgrade.
>
> We have yet to observe the issue returning to a member that has been
> rebooted, but it's still a bit early in the troubleshooting process to
> say that a reboot fixes it for sure.
>
> JTAC claims they saw this issue with 9.2 but not 9.3, and that it was
> very rare.  Meanwhile, we didn't see it until three days after moving
> to 9.3.  They are sticking to the flash corruption line, which I'm
> still not convinced by - they are working on getting the documentation
> they have on the issue.
>
>
> --
> Ross Vandegrift
> ross at kallisti.us
>
> "If the fight gets hot, the songs get hotter.  If the going gets tough,
> the songs get tougher."
>        --Woody Guthrie
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>