[j-nsp] 9.3 and M20 FPC
Eric Van Tol
eric at atlantech.net
Wed May 6 10:14:41 EDT 2009
Hi all,
Is anyone out there running 9.3 with an M20 FPC (not FPC-E). I have a lab box that I've upgraded to 9.3R2.8 and the FPC won't come up. The only PIC in this FPC is a P-4CHDS3 PIC. The FPC basically goes from "Present" state to "Offline" within a few minutes of booting:
May 5 15:07:06 m20 ssb CM(0): Slot 0: No response from FPC interface manager
May 5 15:07:06 m20 chassisd[4671]: CHASSISD_FRU_EVENT: scb_recv_slot_detach: detached FPC 0
May 5 15:07:06 m20 ssb CM(0): Slot 0: No response from FPC chassis manager
May 5 15:07:06 m20 chassisd[4671]: CHASSISD_IFDEV_DETACH_FPC: ifdev_detach(0)
May 5 15:07:06 m20 ssb CM(0): Slot 0: Unrecoverable error; probe failed
I would normally open a ticket, but this is a lab box not under contract that I'm using to test some stuff out on. Everything works fine with 9.0R2.10. Juniper support site says FPC and this PIC are a valid combination for 9.3, so I'm at a loss here.
-evt
More information about the juniper-nsp
mailing list