[j-nsp] 9.3 and M20 FPC
timo at tiscali.net
Wed May 6 10:27:16 EDT 2009
-----BEGIN PGP SIGNED MESSAGE-----
As stated in the reply from Pekka Savola to the threat
"FPC-Offline on M20 after Upgrade JunOS 8.5 to 9.3"
> The very, very old FPC's (prior to E-FPC's) no longer work in 9.3,
> as stated in release notes. This may or may not be related.
Eric Van Tol wrote:
> Hi all,
> Is anyone out there running 9.3 with an M20 FPC (not FPC-E). I have a lab box that I've upgraded to 9.3R2.8 and the FPC won't come up. The only PIC in this FPC is a P-4CHDS3 PIC. The FPC basically goes from "Present" state to "Offline" within a few minutes of booting:
> May 5 15:07:06 m20 ssb CM(0): Slot 0: No response from FPC interface manager
> May 5 15:07:06 m20 chassisd: CHASSISD_FRU_EVENT: scb_recv_slot_detach: detached FPC 0
> May 5 15:07:06 m20 ssb CM(0): Slot 0: No response from FPC chassis manager
> May 5 15:07:06 m20 chassisd: CHASSISD_IFDEV_DETACH_FPC: ifdev_detach(0)
> May 5 15:07:06 m20 ssb CM(0): Slot 0: Unrecoverable error; probe failed
> I would normally open a ticket, but this is a lab box not under contract that I'm using to test some stuff out on. Everything works fine with 9.0R2.10. Juniper support site says FPC and this PIC are a valid combination for 9.3, so I'm at a loss here.
> juniper-nsp mailing list juniper-nsp at puck.nether.net
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
-----END PGP SIGNATURE-----
More information about the juniper-nsp