[j-nsp] Load balacing issue - M7i

[Benny Sumitro]

Hi Tim,

You could do load balancing using M7i, but only works on label-1 or
label-1+label-2 mpls. So you must get those labels to be different. I have
already had this kind of setup in my M10i box with standard CFEB, it should
apply the same with M7i.

BR,
Benny

On Mon, Sep 21, 2009 at 2:40 PM, <tim.hunt at bt.com> wrote:

> It may depend on the environment you are trying to perform load sharing
> in, but we were informed by J-TAC that the M7i CFEB could not perform
> MPLS loadsharing across 2 equal cost paths - I'd love to be proved wrong
> ;-) An Enhanced CFEB would be required :(
>
> May be worth checking with J-TAC for your particular case.
>
> Cheers,
> Tim.
>
> >   On Wed, Sep 16, 2009 at 4:47 PM, Shiva Shankar
> <shankarks at gmail.com>wrote:
> >
> >>  Hi Gebts Ladies.....A quick question on load balancing on juniper
> M7i
> >> running Junos 8.4R2..The config I have on the router is:
> >>
> >> family mpls { label-1;  payload { ip; } }
> >>
> >> The documentation says, for load-balacing (or load sharing per flow),
> the
> >> above uses label-1 (which is VPN label) and bits of IPv4 addess..My
> >> question
> >> is,  (i) does it includes all the bits in an IPv4 address or just few
> bits
> >> of IPv4 address?     cheers
> *******
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>