[j-nsp] SRX3400/3600 Stabie Code Recommendations?

[Rob Cameron]

In 10.2 and later the SRX3XXX and SRX5XXX support ipv6. The command below will turn the feature on.

set security forwarding-options family inet6 mode flow-based

Rob Cameron 
Technical Marketing Engineer - HSS
http://easylink.juniper.net/fwidpwiki
SLT-HSS-TME - Team Alias
(408) 905-9651
robc at juniper.net
www.juniper.net




On Jul 26, 2010, at 6:46 AM, Michael Damkot wrote:

You have to be cautious with the 'that command works' in SRX....

There are a number of things that you can turn 'on' in the SRX, and the UI gives you the feedback that it's working, but it actually doesn't turn on the functionality, because it's not supported etc.... 


On Jul 24, 2010, at 18:15 , Mark Kamichoff wrote:

> On Sat, Jul 24, 2010 at 05:31:13PM -0400, Scott T. Cameron wrote:
>> Only on the low end models,  3400 and higher has no support.
> 
> Oh, that's unfortunate.  I've only had experience with the smaller
> SRXes, and the "set security forwarding-options family inet6 mode
> packet-based" command was all that was needed to enable IPv6.
> 
> - Mark
> 
> -- 
> Mark Kamichoff
> prox at prolixium.com
> http://www.prolixium.com/
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp


_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp