[j-nsp] EX 3200 - no arp entries after power failure

[Chris Morrow]

On Tue, 9 Feb 2010, Paul Waller wrote:

>
> I'm wondering if anybody has seen this issue before.  We have a EX 3200 
> running JunOS 9.2R2 release.  Everytime the switch looses power it boots 
> back up OK but no ARP entries are seen.  I haven't had a chance to see 
> the logs yet but I'm informed this has been happening for sometime & a 
> 2nd reboot of the switch fixes the problem.
>
> Once I look at the config & get the logs then I might post some more but 
> I thought I'd just post this question just in cast somebody had seen

is there a loopback filter on the device? apparently prior to 
9.5<something> on the ex juniper thought filtering ARP in an L3 filter was 
'acceptable'...