[j-nsp] Diagnostic Optics MIB support

[Alessandro Inzerilli]

Hello,

I'm looking for JunOS MIBs giving access to diagnostic optics 
information, basically what you see issuing the CLI command

show interfaces diagnostics optics
Physical interface: so-0/0/0
    Laser bias current                        :  21.392 mA
    Laser output power                        :  0.2970 mW / -5.27 dBm
    Module temperature                        :  46 degrees C / 115 
degrees F
    Module voltage                            :  3.2020 V
    Receiver signal average optical power     :  0.0195 mW / -17.10 dBm
    Laser bias current high alarm             :  Off
    Laser bias current low alarm              :  Off
    Laser bias current high warning           :  Off
    Laser bias current low warning            :  Off
    Laser output power high alarm             :  Off
    Laser output power low alarm              :  Off
    Laser output power high warning           :  Off
    Laser output power low warning            :  Off
    Module temperature high alarm             :  Off
    Module temperature low alarm              :  Off
    Module temperature high warning           :  Off
    Module temperature low warning            :  Off
    Module voltage high alarm                 :  Off
    Module voltage low alarm                  :  Off
    Module voltage high warning               :  Off
    Module voltage low warning                :  Off
    Laser rx power high alarm                 :  Off
    Laser rx power low alarm                  :  Off
    Laser rx power high warning               :  Off
    Laser rx power low warning                :  Off
    Laser bias current high alarm threshold   :  80.000 mA
    Laser bias current low alarm threshold    :  2.000 mA
    Laser bias current high warning threshold :  70.000 mA
    Laser bias current low warning threshold  :  4.000 mA
    Laser output power high alarm threshold   :  1.2590 mW / 1.00 dBm
    Laser output power low alarm threshold    :  0.0440 mW / -13.57 dBm
    Laser output power high warning threshold :  0.7940 mW / -1.00 dBm
    Laser output power low warning threshold  :  0.0700 mW / -11.55 dBm
    Module temperature high alarm threshold   :  110 degrees C / 230 
degrees F
    Module temperature low alarm threshold    :  -40 degrees C / -40 
degrees F
    Module temperature high warning threshold :  93 degrees C / 199 
degrees F
    Module temperature low warning threshold  :  -30 degrees C / -22 
degrees F
    Module voltage high alarm threshold       :  3.900 V
    Module voltage low alarm threshold        :  2.700 V
    Module voltage high warning threshold     :  3.700 V
    Module voltage low warning threshold      :  2.900 V
    Laser rx power high alarm threshold       :  1.1748 mW / 0.70 dBm
    Laser rx power low alarm threshold        :  0.0039 mW / -24.09 dBm
    Laser rx power high warning threshold     :  0.7942 mW / -1.00 dBm
    Laser rx power low warning threshold      :  0.0100 mW / -20.00 dBm


Does anybody know if the MIBs exist? I couldn't find anything on juniper 
tech docs.

Thanks,
Alessandro