[j-nsp] EOMPLS between 10G subinterface and GE subinterface between two 7600 with Juniper MX480 as CE1

[Ioan Branet]

Hello,

I use 7609 with the following IOS:
#sh ver | i IOS
Cisco IOS Software, c7600s72033_rp Software
(c7600s72033_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRB4, RELEASE SOFTWARE
(fc3)

There is no problem with IOS because on another 7609 with same IOS  the
EOMPLS  circuit works the only difference is that on the 7609 on which the
EOMPLS won't works is that i have redundant processors and the following
module:

show module 7
Mod Ports Card Type                              Model              Serial
No.
--- ----- -------------------------------------- ------------------
-----------
  7    4  CEF720 4 port 10-Gigabit Ethernet      WS-X6704-10GE
SAL1337YN4W

Mod MAC addresses                       Hw    Fw           Sw
Status
--- ---------------------------------- ------ ------------ ------------
-------
  7  0025.45a5.fea0 to 0025.45a5.fea3   3.0   12.2(14r)S5  12.2(33)SRB4 Ok

Mod  Sub-Module                  Model              Serial       Hw
Status
---- --------------------------- ------------------ ----------- -------
-------
  7  Distributed Forwarding Card WS-F6700-DFC3CXL   SAL1326T0S6  1.4    Ok

Mod  Online Diag Status
---- -------------------
  7  Pass

On the router on which EOMPLS works I have:

#           sh module 1
Mod Ports Card Type                              Model              Serial
No.
--- ----- -------------------------------------- ------------------
-----------
  1    4  CEF720 4 port 10-Gigabit Ethernet      WS-X6704-10GE
SAL113929UN

Mod MAC addresses                       Hw    Fw           Sw
Status
--- ---------------------------------- ------ ------------ ------------
-------
  1  0019.3037.14fc to 0019.3037.14ff   2.6   12.2(14r)S5  12.2(33)SRB4 Ok

Mod  Sub-Module                  Model              Serial       Hw
Status
---- --------------------------- ------------------ ----------- -------
-------
  1  Distributed Forwarding Card WS-F6700-DFC3CXL   SAL1326SUSG  1.4    Ok

Mod  Online Diag Status
---- -------------------
  1  Pass


Thank you,
John

On Fri, Feb 19, 2010 at 6:13 PM, Mark Tinka <mtinka at globaltransit.net>wrote:

> On Friday 19 February 2010 04:52:30 pm Ioan Branet wrote:
>
> > I used a 6500 instead of 7600 as PE1 and connect this
> >  6500 to Juniper MX (PE1-CE1 link) and it works,it seems
> >  that the problem is with this Cisco 7600,maybe a bug or
> >  something like this.
>
> You probably mentioned this in an earlier post, but just in
> case, what code are you running on the 7600?
>
> Cheers,
>
> Mark.
>