[j-nsp] How to enable IGMP for PPPoE interface on ERX 1410 ?

[guan wang]

Hi All

Anybody know how to enable IGMP for PPPoE interface ? The Radius server has
return "ERX-Igmp-Enable = enable" to ERX .
but the IGMP is still disabled
 IGMP Enable

   - Specifies whether the subscriber can register to receive multicast
   services through Internet Group Management Protocol (IGMP).
   - Value


   - blank—Router uses default setting
   - disable—Disables IGMP
   - enable—Enables IGMP


   - Default—Blank


Code:       Access-Accept
Identifier: 24
Authentic:
<173><231><202>x<238><179><159><251>3<131><246><27>~<25><251><182>
Attributes:
 Framed-IP-Address = 10.0.0.222
 Framed-Protocol = PPP
 ERX-Local-Interface = "loopback100"
 Service-Type = Framed-User
 Framed-IP-Netmask = 255.255.255.255
 ERX-Virtual-Router = "default"
 ERX-Igmp-Enable = enable
 ERX-IGMP-Version = v3
 Acct-Interim-Interval = 3600

ERX1410-LNS1#test aaa ppp test at pppoe.com  xxxxx
************ user attributes *************
Authentication Grant
    idle Timeout - 0
    monitor Ingress Only - false
    session Timeout - 0
    accounting Timeout - 3600
    Client IP Address - 10.0.0.222
    pppoe Maxsession - 0
    Client IP Netmask - 255.255.255.255
    Client IPv6 Interface Id - 0:0:0:0
    primary DNS IP Address - 10.0.0.1
    secondary DNS IP Address - 10.0.0.3
    primary IPv6 DNS IP Address - ::
    secondary IPv6 DNS IP Address - ::
    primary WINS IP Address - 0.0.0.0
    secondary WINS IP Address - 0.0.0.0
    SA Validate - disabled
    IGMP - disabled
    Ignore-DF-Bit - disabled
    MLD Version - MLD Version not set
    IGMP Version - IGMP Version: 3
    IP Interface Block Multicast Sources - disabled
    Mobile IP algorithm - not set
    Mobile IP SPI - not set
    Mobile IP Key - not set
    Mobile IP Replays - not set


Thanks
WangGuan