[j-nsp] BPDU Question

chrisccnpspam2 at gmail.com chrisccnpspam2 at gmail.com
Tue Mar 23 10:30:15 EDT 2010

What is the answer? :) 
------Original Message------
From: Paul Stewart
Sender: juniper-nsp-bounces at puck.nether.net
To: juniper-nsp at puck.nether.net
Subject: [j-nsp] BPDU Question
Sent: Mar 23, 2010 10:21 AM

Hi folks .. thanks to those who replied offline to my last question
(speed/duplex) - the answer was sitting right in front of me the whole time


I have a new problem ... with our EX4200's we face many customer switches
and I need to filter BPDU's out.  In the Cisco world we would setup a port
just like this:


interface GigabitEthernet3/2

 description xxxxxxxxxxx


 switchport access vlan 66

 switchport mode access

 switchport nonegotiate

 no ip address

 no cdp enable

 no mop enabled

 spanning-tree bpdufilter enable



What is the equivalent to this in Juniper?  I tried setting up "bpdu
protect" one some interfaces but when it does see a BPDU packet it shuts the
port down - we can't have that occur ... we just want to filter out


Thanks ;)




juniper-nsp mailing list juniper-nsp at puck.nether.net

Sent via BlackBerry by AT&T

More information about the juniper-nsp mailing list