[j-nsp] EX4200 24 SFP ports not showing

Paul Stewart paul at paulstewart.org
Mon May 31 19:00:53 EDT 2010


Configure the other ports - even if it's just setting them to "family
Ethernet-switching" for now ... this will cause them to show up and be part
of the configuration....

Paul


-----Original Message-----
From: juniper-nsp-bounces at puck.nether.net
[mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of Olof Kasselstrand
Sent: May-31-10 6:53 PM
To: juniper-nsp
Subject: [j-nsp] EX4200 24 SFP ports not showing

Hi,

I have a EX4200 24 SFPs switch. When I try show interface terse only
the port with SFP is shown. If I do a show inter ge-0/0/7 I get device
not found if there is no SFP plugged in. Is it possible to change
this?

This is causing me trouble when I want to setup graphs for this
switch. The interfaces don't show up in SNMP either. It would be nice
to add all ports and as soon as I start using one port I'll get the
graphs.

Thanks, Olof
_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp




More information about the juniper-nsp mailing list