[j-nsp] SRX100 reset

[Giuliano Cardozo Medalha]

  You can use:

http://kb.juniper.net/index?page=content&id=KB15725&smlogin=true

After you reset the box:

delete security
set security forwarding-options family mpls mode packet-based
set security forwarding-options family inet6 mode packet-based

It will work like a common router without security zones or statefull 
firewall.

You can disable some process that you do not use:

set system process isdn disable


> Hi,
>
> had the same problem when I first unpacked my SRX100. It requested an IP
> address but was not reachable at all by that address.
> I don't remember the exact way i finally fixed it that night, but there
> was something wrong with the VLAN/port-assignments (and maybe even
> zones) in the factory default config.
> You might want to try another port first, as fe-0/0/0 is [supposed to
> be] in the untrust and fe-0/0/1-7 in trust zone.
> If this doesn't work, check the config via serial cable and put one
> specific port into trust and manually assign an IP address to it.
>
> I clearly remember that for 1 or 2 hours I thought the device was
> broken, as it did not work at all, even following the quickstart guide.
>
> best regards,
> Volker
>
> Stefan Schlesinger wrote:
>> Hello Folks,
>>
>> I'm trying to reset my SRX100. When I press the Reset button the status
>> light turns amber, the SRX requests an IP address from my DHCP server,
>> I see an ARP entry, but I cannot ping it nor connect to it
>> using telnet/ssh/http.
>>
>> What could be the reason for this and how can I do a factory reset?
>>
>> Thanks,
>>
>> Stefan.
>> _______________________________________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/juniper-nsp
>>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>