[j-nsp] Chassis Cluster - Strange behavior

[Scott T. Cameron]

You disconnected the cables but didn't delete the chassis cluster config, is
that right?

Delete the chassis cluster.

Scott

On Fri, Sep 17, 2010 at 11:04 AM, Fahad Khan <fahad.khan at gmail.com> wrote:

> Hi Folks,
>
> I have been running SRX3600 In chassis cluster.
>
> At the moment, I have disconnected control link and fabric link and
> Secondary device is isolated from the network. But on primary device, the
> cluster configs are still there. The network is working fine with primary
> device but when i see chassis cluster status, i find this
>
> SRX3600-A> show chassis cluster status
> Cluster ID: 1
> Node                  Priority          Status    Preempt  Manual failover
>
> Redundancy group: 0 , Failover count: 1
>    node0                   254         primary        no       no
>    node1                   0           lost           n/a      n/a
>
> Redundancy group: 1 , Failover count: 1
>    node0                   0           primary        yes      no
>    node1                   0           lost           n/a      n/a
>
> why I am getting Node0 priority as 0 for red group 1, while i has been set
> to 254???
>
> have any body experienced?????
>
> thanks and regards,
>
>
> Muhammad Fahad Khan
> JNCIP - M/T # 834
> IT Specialist
> Global Technology Services, IBM
> fahad at pk.ibm.com
> +92-301-8247638
> Skype: fahad-ibm
> http://pk.linkedin.com/in/muhammadfahadkhan
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>