[j-nsp] fxp0 configuration under groups.

[David Lockuan]

Hi Keith,

I think that you forget to set the group "re0" in the apply-group global.
You need to set the following command.

set apply-groups re0

To try with this and put your commit confirmed 2.

Best regards,

David.


On Tue, Feb 1, 2011 at 5:37 PM, Keith <kwoody at citywest.ca> wrote:

> Hi.
>
> I have the MX setup with fxp0 that is attached to RE0 as a
> regular interface with an IP.
>
> I was wanting to setup redundant RE's so following Juniper's documentation
> it shows:
>
> set groups re0
> edit groups re0
> set system host-name <name>
> set interfaces fxp0 unit 0 family inet address <address/mask>
>
> As I am 100 miles away from this box, if I set interfaces under the groups,
> will it move the fxp0 I am using now on RE0 to the group and kill my
> connectivity?
>
> I should probably only do this locally as I have used commit confirmed 2 a
> few times as I have managed to lock myself out of the router twice now.
>
> Thanks,
> Keith
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>