[j-nsp] Configure BGP on SSG 550M

[David Lubowa]

Rafael,

Thank you for this but i managed to set this up almost 3 hours after i
posted this thread, and i have BGP running fine now.


cheers



On Tue, Feb 15, 2011 at 10:42 PM, Rafael Rodriguez
<packetjockey at gmail.com>wrote:

> Hi David,
>
> You probably want to look into:
>
> http://www.juniper.net/techpubs/software/screenos/screenos6.3.0/630_ce_all.pdf
>
> Should be in Routing -> Border Gateway Protocol.
>
> BTW, this covers BGP on screenos based devices and not junos devices.
>
> On Tue, Feb 1, 2011 at 3:22 AM, David Lubowa <david.lubowa at gmail.com>wrote:
>
>> Hi Guys,
>>
>> I am pretty virgin when it comes to Juniper but i switched because i think
>> its amazing gear , i am trying to configure BGP on my SSG550M using a
>> private ASN( just for now ) to my upstream but i am not sure where to
>> start
>> i have looked for some documentation online but i am still not yet
>> convinced
>> on which is the right documentation because the information is all
>> scattered.
>>
>> If someone could please point me in the right direction i would be happy ,
>> FYI i setup BGP on cisco gear a couple of years ago and i understand the
>> basic facts of BGP but i am not sure exactly how to set it up on Juniper.
>>
>> Your help is highly appreciated.
>>
>> cheers
>>
>>
>> --
>>
>>
>>
>>
>>
>> "I will not say i failed 1000 Times, I will say that i discovered there
>> are
>> 1000 ways that can cause failure. ---- Thomas Edison"
>> _______________________________________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/juniper-nsp
>>
>
>


-- 





"I will not say i failed 1000 Times, I will say that i discovered there are
1000 ways that can cause failure. ---- Thomas Edison"