[j-nsp] nssa default route

[ryanL]

i will give that a shot, harry. thank you. this triggers a question,
however. is it better to redist a static discard default route so it
shows up as NSSA on my area 1 routers, instead of as a summary? this
would negate the need for this mystery command, yes?

On Thu, Aug 16, 2012 at 11:28 AM, Harry Reynolds <harry at juniper.net> wrote:
> Does the "remaining" mx have an active area 0 adjacency, or just an area 0 interface? IIRC, you need the former. In theory, if there is no area 0 adjacency, then when send the default? Where will the resulting inter-area traffic go? Routers in the nssa should not need the default just to get to the abr, it's needed to get to the best abr that can then shunt you over or into area 0, but that requires an area 0 adjacency.
>
> Have you tried the disable statement and if so, any change?
>
> Regards
>