[j-nsp] EX4200 Virtual Chassis Uplink Requirements - Extended VCT / VCCP

[Chuck Anderson]

On Mon, Jun 25, 2012 at 06:23:36AM +0000, Paul Zugnoni wrote:
> It had its limitations, though:
>   * This was on 10.1. No ISSU available, so couldn't set a high SLA
>   * No SNMP polling was available then of the fiber VC ports. If you had
> issues with dirty fiber or weak signal, you'd have to find out via the CLI
> (which happened to us on a different, more local implementation over
> single mode).
>   * Not being able to follow a route or a mac address-table to see which
> inter-city link was being used to reach a particular destination

You can use this command to see the route a frame takes:

ex> show virtual-chassis vc-path source-interface ge-a/b/c destination-interface ge-x/y/z