[j-nsp] EX4200 Virtual Chassis Uplink Requirements - Extended VCT / VCCP

[Paul Zugnoni]

Awesome! Thanks Chuck


On 6/25/12 9:13 AM, "Chuck Anderson" <cra at wpi.edu> wrote:

>On Mon, Jun 25, 2012 at 06:23:36AM +0000, Paul Zugnoni wrote:
>> It had its limitations, though:
>>   * This was on 10.1. No ISSU available, so couldn't set a high SLA
>>   * No SNMP polling was available then of the fiber VC ports. If you had
>> issues with dirty fiber or weak signal, you'd have to find out via the
>>CLI
>> (which happened to us on a different, more local implementation over
>> single mode).
>>   * Not being able to follow a route or a mac address-table to see which
>> inter-city link was being used to reach a particular destination
>
>You can use this command to see the route a frame takes:
>
>ex> show virtual-chassis vc-path source-interface ge-a/b/c
>destination-interface ge-x/y/z
>_______________________________________________
>juniper-nsp mailing list juniper-nsp at puck.nether.net
>https://puck.nether.net/mailman/listinfo/juniper-nsp