[j-nsp] Set weight (BGP attribute) in JunOS

[Ali Sumsam]

Hi All,
I am configuring BGP for one of my customer's MX-5 router. I need to
configure the BGP attribute "weight"
Is there any way of assigning "weight" attribute on subnets learned from an
EBGP peer.

Cisco config of this is as following.


router bgp 123

neighbor pipe-bne soft-reconfiguration inbound

neighbor pipe-bne route-map ABC-IN in



route-map ABC-IN permit 10

 set weight 1500


I googled it and found following, which kinda says that we cant play with
weight attribute in policies. Is this correct?

http://www.juniper.net/techpubs/software/erx/erx41x/swconfig-routing-vol2/html/bgp-config9.html

Regards,
*Ali Sumsam CCIE*
*Network Engineer - Level 3*
eintellego Pty Ltd
ali at eintellego.net ; www.eintellego.net

Phone: 1300 753 383 ; Fax: (+612) 8572 9954

Cell +61 (0)410 603 531

facebook.com/eintellego
PO Box 7726, Baulkham Hills, NSW 1755 Australia

The Experts Who The Experts Call
Juniper - Cisco – Brocade - IBM