[j-nsp] Set weight (BGP attribute) in JunOS

[Mihai]

Hello,

  Weight is a Cisco proprietary thing and cannot be used with a Juniper 
device. Maybe you could use preference (not local-preference).


On 11/25/2012 10:03 AM, Ali Sumsam wrote:
> Hi All,
> I am configuring BGP for one of my customer's MX-5 router. I need to
> configure the BGP attribute "weight"
> Is there any way of assigning "weight" attribute on subnets learned from an
> EBGP peer.
>
> Cisco config of this is as following.
>
>
> router bgp 123
>
> neighbor pipe-bne soft-reconfiguration inbound
>
> neighbor pipe-bne route-map ABC-IN in
>
>
>
> route-map ABC-IN permit 10
>
>   set weight 1500
>
>
> I googled it and found following, which kinda says that we cant play with
> weight attribute in policies. Is this correct?
>
> http://www.juniper.net/techpubs/software/erx/erx41x/swconfig-routing-vol2/html/bgp-config9.html
>
> Regards,
> *Ali Sumsam CCIE*
> *Network Engineer - Level 3*
> eintellego Pty Ltd
> ali at eintellego.net ; www.eintellego.net
>
> Phone: 1300 753 383 ; Fax: (+612) 8572 9954
>
> Cell +61 (0)410 603 531
>
> facebook.com/eintellego
> PO Box 7726, Baulkham Hills, NSW 1755 Australia
>
> The Experts Who The Experts Call
> Juniper - Cisco – Brocade - IBM
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp