[j-nsp] MX5-error while booting.

[Ali Sumsam]

Hi,

My new MX5 died today. If I try to boot it up, it stuck at following
message.

U-Boot 1.1.6 (Jun 10 2011 - 00:50:30)

CPU:   8572, Version: 2.1, (0x80e00021)
Core0:  E500, Version: 3.0, (0x80210030)
Clock Configuration:
       CPU0:1333 MHz,        CPU1:1333 MHz, CCB: 533 MHz,
       DDR: 267 MHz (533 MT/s data rate) (Synchronous), LBC:  33 MHz
L1:    D-cache 32 kB enabled
       I-cache 32 kB enabled
Board: MX5-T 1.8
CPLD:  Version 0x1f
DRAM:  Initializing  -     DDR: 2048 MB
Testing DRAM from 0x00000000 to 0x80000000
DRAM test phase 1:
DRAM test fails at: 7ff63e24
hang at function = 0xfffbe504
### ERROR ### Please RESET the board ###


Any suggestions?

Regards,

*Ali Sumsam CCIE*
*Network Engineer - Level 3*
eintellego Pty Ltd
ali at eintellego.net ; www.eintellego.net

Phone: 1300 753 383 ; Fax: (+612) 8572 9954

Cell +61 (0)410 603 531

facebook.com/eintellego
PO Box 7726, Baulkham Hills, NSW 1755 Australia

The Experts Who The Experts Call
Juniper - Cisco – Brocade - IBM