[j-nsp] M10i

[Michel de Nostredame]

Ah~ M20 does not support 10GE interface, also M20 is already EOL.
MX could be good choice, see

http://www.juniper.net/us/en/local/pdf/datasheets/1000378-en.pdf
for MX80 cards, and

http://www.juniper.net/us/en/products-services/routing/mx-series/
for all MX series.

--
Michel~

On Tue, Apr 9, 2013 at 7:07 PM, Jonathan Lassoff <jof at thejof.com> wrote:
> I think you'll need at least an M20 for your 10 GigE requirement as well as
> SDH.
>
> If you can somehow get a different transit circuit than your SDH one, an
> MX5 would be a much closer (throughput-wise) and better bang-for-your-buck
> replacement for a 7206 than an M-series.
> J-series with a T1 module could also work, depending on your "STM-1".
>
> If you need SDH though, you'll need M or T. J can do T1s.
>
> --j
>
> On Tue, Apr 9, 2013 at 6:28 PM, Orlando Cordova Gonzales <
> orlando.cordova.gonzales at gmail.com> wrote:
>
>> hello,
>>
>> I need to change a CISCO 7206 router that computer I recommend one of the
>> requirements is that you have two 10G interfacez two interfacez 1G and STM1
>> interface to connect with the ISP was thinking M10i Router but I do not
>> support 10g interface.
>>
>> thank you very much for your help.
>> _______________________________________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/juniper-nsp
>>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp