[j-nsp] LIBJNX_SNMP_ENGINE_SCAN_FAILURE and commit

Maciej Jan Broniarz gausus at gausus.net
Sat May 25 10:07:18 EDT 2013


On Sat, May 25, 2013 at 12:29:12PM +0100, Phil Mayers wrote:
> On 25/05/2013 12:01, Maciej Jan Broniarz wrote:


Hello,

> >I am trying to do an initial setup on an SRX1400 but i get the following error:
> >
> >root# commit
> >[edit groups junos-defaults]
> >   'interfaces'
> >     Error accessing interface container object, may not be defined
> >LIBJNX_SNMP_ENGINE_SCAN_FAILURE: snmp_engine_read: fscanf : /var/db/snmp_engine.db scanning: full_engine_id Error: Unknown error: 0
> >[edit groups junos-defaults]
> >   'interfaces'
> >     cannot get intferface name.
> >error: configuration check-out failed
> >
> >[edit]
> >
> >How should I fix it?
> 
> We saw this recently on SRX3600, but I can't remember what the
> solution was; if I recall correctly, there is some mandatory minimum
> config that the setup guide omits, but I can't quite remember what
> it was...
> 
> What does "show interfaces" in "configure" mode look like before you
> try to commit?

It shows nothing :(

mjb


More information about the juniper-nsp mailing list