[j-nsp] MX480 BNG
Brijesh Patel
brju.patel at gmail.com
Mon Jun 2 10:45:35 EDT 2014
Hello Folks,
I created multiple L2circuit over interface xe-0/0/0 MX480 and Alcatel SR
7750 . Status of l2circuts is UP. Attached configuration FYI pls.
Now I am trying to emulate PPoE connection over new circuit(VCID 10000
which is up) with using of N2X tester but session is not established.
Any idea or How do I troubleshoot PPOE connection ?
Many Thanks,
Brijesh Patel
-------------- next part --------------
y135912 at Nevri-BNG-J480-01> show configuration interfaces xe-0/0/0.300
encapsulation vlan-ccc;
vlan-id 300;
input-vlan-map pop;
output-vlan-map push;
family ccc {
filter {
input ccc-filter;
}
}
{master}
y135912 at Nevri-BNG-J480-01> show configuration protocols l2circuit neighbor 172.130.124.11 interface xe-0/0/0.300
virtual-circuit-id 10000;
{master}
y135912 at Nevri-BNG-J480-01> show l2circuit connections interface xe-0/0/0.300
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid NP -- interface h/w not present
MM -- mtu mismatch Dn -- down
EM -- encapsulation mismatch VC-Dn -- Virtual circuit Down
CM -- control-word mismatch Up -- operational
VM -- vlan id mismatch CF -- Call admission control failure
OL -- no outgoing label IB -- TDM incompatible bitrate
NC -- intf encaps not CCC/TCC TM -- TDM misconfiguration
BK -- Backup Connection ST -- Standby Connection
CB -- rcvd cell-bundle size bad SP -- Static Pseudowire
LD -- local site signaled down RS -- remote site standby
RD -- remote site signaled down XX -- unknown
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 172.130.124.11
Interface Type St Time last up # Up trans
xe-0/0/0.300(vc 10000) rmt Up Jun 2 11:50:22 2014 1
Remote PE: 172.130.124.11, Negotiated control-word: No
Incoming label: 304848, Outgoing label: 130781
Negotiated PW status TLV: No
Local interface: xe-0/0/0.300, Status: Up, Encapsulation: ETHERNET
{master}
y135912 at Nevri-BNG-J480-01>
More information about the juniper-nsp
mailing list