[j-nsp] L2 tunnel over IP on ex4200-24t

[Mark Tees]

That's right. EX4500 series is different and supports a bunch more
MPLS features :)

Which I just noticed that since 12.2 apparently MPLS over RVI's and
layer 3 sub-interfaces is apparently supported.



On Tue, May 12, 2015 at 8:22 PM, Raphael Mazelier <raph at futomaki.net> wrote:
>
>
> Le 12/05/15 10:27, Mark Tees a écrit :
>>
>> l2circuit is not supported as that requires a two label stack to work.
>>
>> EX4200's can only switch a 1 label stack. Any traffic passed in  P/LSR
>> fashion that has more than 1 label in the stack gets dropped
>> transparently from what I have seen, regardless of what the control
>> plane/RE said.
>>
>> ccc/remote-interface-switch like in the link I sent earlier is the
>> only way that works as far as I have seen. This is probably because of
>> the 1:1 mapping of LSP to ccc direction.
>>
>
> Strange, because what I tested on Ex4550 is the opposite :
> l2circuit are working, ccc not.
>
> --
> Raphael Mazelier



-- 
Regards,

Mark L. Tees