[j-nsp] Upgrading firmware on an EX 4300 virtual chassis?

[Ivan Ivanov]

Hi,

You might want to upgrade to latest service release for EX4300 (see the
link below)

http://kb.juniper.net/InfoCenter/index?page=content&id=S:TSB16691&smlogin=true

HTH
Ivan,


On Wed, May 27, 2015 at 4:00 PM, Scott Granados <scott at granados-llc.net>
wrote:

> Hi,
> I’ve downloaded the latest recommended firmware from the web site which is
> indicated as jinstall-ex-4300-13.2X51-D35.3-domestic-signed.tgz.  I’ve been
> googling and keep finding procedures for upgrading that involve NSSU which
> I’ve seen go very badly all be it quite a while ago, before the feature was
> supported.  Will the normal method work?  Will something like the following
> do the job
>
> >request system software add
> /var/tmp/jinstall-ex-4300-13.2X51-D35.3-domestic-signed.tgz validate no-copy
> Once completed and valided
> >request system reboot
>
> Will this fit the bill or do I have to use the new procedures?  If this
> will work is there any need to define all members or is that assumed?
> What’s my best upgrade procedure to proceed?  Also, any comments on the
> version that the site presented as acceptable, should I go with this
> release or is something else more preferred?
>
> I’m presently running a buggy version of 13.2 that was shipped with the
> devices.
>
> Any pointers would be most appreciated.
>
> Thank you
> Scott
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>



-- 
Best Regards!

Ivan Ivanov