[j-nsp] Routed VLAN Interfaces on MX

Bill Blackford bblackford at gmail.com
Fri Nov 13 16:25:28 EST 2015


in your bridge-domains stanza, add 'domain-type bridge' and I think you're
golden.

-b



On Fri, Nov 13, 2015 at 1:12 PM, Josh Baird <joshbaird at gmail.com> wrote:

> Hi,
>
> I apologize for the basic question as I'm a new Junos user.  I'm attempting
> to convert the following basic config from a Cisco NPE-G1:
>
> interface GigabitEthernet0/3
>  desc 'Physical link to EX'
>
> interface GigabitEthernet0/3.41
>   encapsulation dot1q
>   ip address 1.1.1.2/30
>
> On the MX, I am trying to configure an agg between the MX and other device
> (EX), so this is the config that I have came up with:
>
> # interfaces
> ae0 {
>     flexible-vlan-tagging;
>     encapsulation flexible-ethernet-services;
>     aggregated-ether-options {
>         lacp {
>             active;
>             periodic fast;
>         }
>     }
>     unit 41 {
>         encapsulation vlan-bridge;
>         vlan-id 41;
>     }
> }
>
> # interfaces irb
> irb {
>     unit 41 {
>         family inet {
>             address 1.1.1.2/30
>         }
>     }
> }
>
>
> # bridge-domain
> bridge-domains {
>     vlan41 {
>         vlan-id 41;
>         interface ae0.41;
>         routing-interface irb.41;
>     }
> }
>
> Does this configuration look correct?  Is all of this necessary?  I realize
> there are several different ways to handle this in Junos.
>
> Thanks for any suggestions or input.
>
> Josh
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>



-- 
Bill Blackford

Logged into reality and abusing my sudo privileges.....


More information about the juniper-nsp mailing list