[j-nsp] MPLS L2VPN Cisco and Juniper

[Mohammad Khalil]

I have configured the below
set interfaces em0 mtu 1514
set interfaces em0 unit 0 family inet address 192.168.101.10/24
set interfaces em0 unit 0 family mpls mtu 1500
set interfaces em1 vlan-tagging
set interfaces em1 unit 100 encapsulation vlan-ccc
set interfaces em1 unit 100 vlan-id 100
set interfaces em1 unit 100 family ccc
set interfaces lo0 unit 0 family inet address 10.10.10.10/32
set routing-options router-id 10.10.10.10
set routing-options autonomous-system 20
set protocols mpls interface em0.0
set protocols mpls interface lo0.0
set protocols ospf area 0.0.0.0 interface em0.0
set protocols ospf area 0.0.0.0 interface lo0.0
set protocols ldp interface em0.0
set protocols ldp interface lo0.0
set protocols l2circuit neighbor 1.1.1.1 interface em1.100
virtual-circuit-id 100

router ospf 1
 router-id 1.1.1.1
 network 1.1.1.1 0.0.0.0 area 0
 network 192.168.101.1 0.0.0.0 area 0
R1#sh run int f1/1.100
Building configuration...

Current configuration : 107 bytes
!
interface FastEthernet1/1.100
 encapsulation dot1Q 100
 xconnect 10.10.10.10 100 encapsulation mpls
end

But its not working even the circuit is up (not working means no ping
between CEs)

BR,
Mohammad

On Mon, Apr 18, 2016 at 2:47 PM, Mohammad Khalil <eng.mssk at gmail.com> wrote:

> Thanks Steinar
> So we are talking about xconnect from Cisco side and l2circuit from
> Juniper side right?
> Do you have a running template please?
>
> Thanks in advance
>
> BR,
> Mohammad
>
> On Mon, Apr 18, 2016 at 1:49 PM, <sthaug at nethelp.no> wrote:
>
>> > Am trying to configure MPLS L2VPN between Cisco and Juniper
>> > I know in Cisco VPLS and xconnect
>> > In juniper l2vpn and l2circuit (Kompella and Martini respectively)
>> > What are the compatible methods to follow in this case?
>>
>> Point to point (pseudowire, Martini tunnel) is very much interoperable
>> between Cisco and Juniper. We have lots of these in operation.
>>
>> Steinar Haug, Nethelp consulting, sthaug at nethelp.no
>>
>
>