[j-nsp] MPLS L2VPN Cisco and Juniper

[Alexander Arseniev]

Hello,
If You are doing the below JUNOS config on Olive, L2circuit data plane 
does not work on Olive.
And it never worked on Olive, to my knowledge.
HTH
Thx
Alex

On 18/04/2016 13:32, Mohammad Khalil wrote:
> I have configured the below
> set interfaces em0 mtu 1514
> set interfaces em0 unit 0 family inet address 192.168.101.10/24
> set interfaces em0 unit 0 family mpls mtu 1500
> set interfaces em1 vlan-tagging
> set interfaces em1 unit 100 encapsulation vlan-ccc
> set interfaces em1 unit 100 vlan-id 100
> set interfaces em1 unit 100 family ccc
> set interfaces lo0 unit 0 family inet address 10.10.10.10/32
> set routing-options router-id 10.10.10.10
> set routing-options autonomous-system 20
> set protocols mpls interface em0.0
> set protocols mpls interface lo0.0
> set protocols ospf area 0.0.0.0 interface em0.0
> set protocols ospf area 0.0.0.0 interface lo0.0
> set protocols ldp interface em0.0
> set protocols ldp interface lo0.0
> set protocols l2circuit neighbor 1.1.1.1 interface em1.100
> virtual-circuit-id 100
>
> router ospf 1
>   router-id 1.1.1.1
>   network 1.1.1.1 0.0.0.0 area 0
>   network 192.168.101.1 0.0.0.0 area 0
> R1#sh run int f1/1.100
> Building configuration...
>
> Current configuration : 107 bytes
> !
> interface FastEthernet1/1.100
>   encapsulation dot1Q 100
>   xconnect 10.10.10.10 100 encapsulation mpls
> end
>
> But its not working even the circuit is up (not working means no ping
> between CEs)
>
> BR,
> Mohammad
>
> On Mon, Apr 18, 2016 at 2:47 PM, Mohammad Khalil <eng.mssk at gmail.com> wrote:
>
>> Thanks Steinar
>> So we are talking about xconnect from Cisco side and l2circuit from
>> Juniper side right?
>> Do you have a running template please?
>>
>> Thanks in advance
>>
>> BR,
>> Mohammad
>>
>> On Mon, Apr 18, 2016 at 1:49 PM, <sthaug at nethelp.no> wrote:
>>
>>>> Am trying to configure MPLS L2VPN between Cisco and Juniper
>>>> I know in Cisco VPLS and xconnect
>>>> In juniper l2vpn and l2circuit (Kompella and Martini respectively)
>>>> What are the compatible methods to follow in this case?
>>> Point to point (pseudowire, Martini tunnel) is very much interoperable
>>> between Cisco and Juniper. We have lots of these in operation.
>>>
>>> Steinar Haug, Nethelp consulting, sthaug at nethelp.no
>>>
>>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp