[j-nsp] BGP/MPLS Question MX Platform
Dean Bolton
jnprlist at gmail.com
Tue Aug 2 16:35:43 EDT 2016
I haven't tested it, but one thought I had was to put MPLS/LDP inside
logical systems on the nodes and only include the A-C link inside the
logical systems. In theory this should work but seems a bit of a
hack...but maybe I'm down to hacks to make this work anyway..lol
On Tue, Aug 2, 2016 at 3:22 PM, Mark Tinka <mark.tinka at seacom.mu> wrote:
>
>
> On 2/Aug/16 22:14, Dean Bolton wrote:
>
> Hi,
>
> I have a small network with 3 nodes that are connected in a "ring", ie A to
> B, B to C, C to A. I'm running MPLS w/LDP for l2circuits and ISIS as the
> IGP. MPLS is working fine including if one of the links fails. Nodes A
> and C also have IP transit connections to upstream carriers and all three
> nodes have BGP setup. What I would like to do is prevent BGP from using
> the A to C link for any traffic or only traffic that I specify and the A to
> C link only be used for MPLS. I haven't quite been able to figure out how
> one could accomplish that since the loopbacks are reachable via MPLS and/or
> IGP and they will use that link during a failure of A-B or B-C.
>
>
> If you use LDP as your label distribution protocol, this will be difficult.
>
> I could see you solving this by using RSVP, but I'm only theorizing this,
> as I'd be wary of having a partitioned MPLS network within the same IGP
> domain. Strange things could happen if MPLS-switched traffic ends up on a
> link that has no MPLS capabilities.
>
> Mark.
>
>
More information about the juniper-nsp
mailing list