[j-nsp] vMX

[Alexander Marhold]

Hi Yes !

By changing parameters in the boot/loader.conf you can change certain
behavior

vm_chassis_i2cid="21" for MX960, "33" for MX480, and "48" for MX240
 vm_ore_present=“0” for a single RE; vm_ore_present=“1” for dual REs
vm_instance=“0” for the the RE, the first FPC slot; vm_instance=“1” for
second FPC
slot, and so on (not applicable to RE)
Let’s say, you want to run 1 RE and 1 FPC on slot 0 (you can run 2 REs and
up to 12 FPCs if
you emulate an MX960)

However the real imitation is somewhere else  namely that VMware only allow
up to 10 interfaces on one VM

I think that currently this is not officially supported but as far as I know
Juniper plans to allow up to 2 REs and up to ?(3 and more) separate PFE
instances

With best regards

alexander

-----Ursprüngliche Nachricht-----
Von: juniper-nsp [mailto:juniper-nsp-bounces at puck.nether.net] Im Auftrag von
Stefan Stoyanov
Gesendet: Donnerstag, 17. November 2016 15:12
An: juniper-nsp at puck.nether.net
Betreff: [j-nsp] vMX

Hello everyone,

Is there someone who is familiar with vMX?
I have installed vMX under VMWARE and I wanted to know if it's possible to
add more than one FPC.
I could find any documentation about that.

Thanks.
_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp