[j-nsp] EX4600 : Ping problem

[Eduardo Schoedler]

Here on EX2200 I put ip address directly in the vlan.

Try this:

set interfaces vlan unit xxx family inet address 10.x.x.x/24
set vlans vlan-RESEAUX l3-interface vlan.xxx
set interfaces ge-0/x/x unit 0 family ethernet-switching vlan members
vlan-RESEAUX

Regards,

2016-11-28 17:55 GMT-02:00 Deloin via juniper-nsp <juniper-nsp at puck.nether.net>:
>
> Hello,
>
> I have 2 EX4600 switchs.
> They have the same symetric configurations:
>
>
> SWITCH EX4600-1                        SWITCH EX4600-2
>
> interfaces {                           interfaces {
>   xe-0/0/1 {                             xe-0/0/1 {
>     unit 0 {                               unit 0 {
>       family ethernet-switching {            family ethernet-switching {
>         interface-mode access;                 interface-mode access;
>         vlan {                                 vlan {
>           members vlan-RESEAUX;                  members vlan-RESEAUX;
>         }                                      }
>         storm-control default;                 storm-control default;
>       }                                      }
>     }                                      }
>   }                                      }
>
>   irb {                                  irb {
>     unit 0 {                               unit 0 {
>       family inet {                          family inet {
>         address 10.101.0.4/16;                 address 10.101.0.5/16;
>       }                                      }
>     }                                      }
>   }                                      }
> }                                      }
>
>
> routing-options {                      routing-options {
>   static {                               static {
>     route 0.0.0.0/0 next-hop 10.101.0.1;   route 0.0.0.0/0 next-hop 10.101.0.1;
>   }                                      }
> }                                      }
>
>
> vlans {                                vlans {
>   default {                              default {
>     vlan-id 1;                             vlan-id 1;
>   }                                      }
>
>   vlan-RESEAUX {                         vlan-RESEAUX {
>     vlan-id 98;                            vlan-id 98;
>     l3.interface irb.0;                    l3.interface irb.0;
>   }                                      }
> }                                      }
>
> I put an optic fiber between xe-0/0/1 from a switch and xe-0/0/1 from the other switch.
> And I can't ping the @ 10.101.0.3 and 10.101.0.4 from each switchs.
> I obtain :
> root at EX4600-01# run ping 10.101.0.3
> PING 10.101.0.3 (10.101.0.3): 56 data bytes
> ping: sendto: No route to host
> ping: sendto: No route to host
> ping: sendto: No route to host
> ping: sendto: No route to host
> the same for the other.
>
> Can you help me. Can you tell me where is the mistake, or what I forget ?
>
> Thank you !
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp



-- 
Eduardo Schoedler