[j-nsp] EX4600 : Ping problem

[Dale Shaw]

Hi Eduardo,

On 29 November 2016 at 08:35, Eduardo Schoedler <listas at esds.com.br> wrote:
>
> Here on EX2200 I put ip address directly in the vlan.
>
> Try this:
>
> set interfaces vlan unit xxx family inet address 10.x.x.x/24
> set vlans vlan-RESEAUX l3-interface vlan.xxx
> set interfaces ge-0/x/x unit 0 family ethernet-switching vlan members
> vlan-RESEAUX

EX4600 runs Enhanced Layer 2 Software (ELS), so it's correct to use "irb.n"
vs. "vlan.n"

I assume Deloin's config was hand-typed because it should be "l3-interface"
rather than "l3.interface". As someone else pointed out, if the link is
point-to-point, only .4 and .5 will be reachable.

xe-0/0/1 is the 2nd (bottom left) interface.

We need some more "show" outputs and/or a complete config to figure out
what's going on.

Cheers,
Dale