[j-nsp] ACX5048 - 40 gbps ER 40 km optic

Chuck Anderson cra at WPI.EDU
Thu Oct 5 09:33:40 EDT 2017


Insert a 3dB or 7dB attenuator pad for lab testing.  In a pinch (no pun intended) you can take a fiber jumper and bend it tightly into a loop (like 1/4" diameter) to attenuate the signal, but I would use a disposable jumper for that.  Use a twist tie or similar to hold it in the tight loop.  Monitor the receive power level while adjusting the tightness of the loop until it is lower than -5 dBm but higher than -20 dBm.

On Wed, Oct 04, 2017 at 07:04:05PM -0500, Aaron Gould wrote:
> Well, when the transport eng I work with found out that I had these two 40km optics connected with a 3’ jumper he ran into the lab to disconnect it…. So that’s probably why you see no light right now…. Lemme get back into the office Monday and we will go from there… yeah, as I mentioned I’m working with my Juniper account SE on this, so he may update support matrix if he discovers they are good…. I dunno.


More information about the juniper-nsp mailing list