[j-nsp] SRX100 u-boot

[Mohammad Khalil]

Dears
I have formatted the USB using FAT32 , placed the image
Physical reset took place and now the nand_format is repeating itself !

On Sun, 11 Nov 2018 at 15:12, Mohammad Khalil <eng.mssk at gmail.com> wrote:

> Thanks mate for the help
> Actually , am stuck at the => and cannot reach the loader
> I hit boot and nothing happened
> setenv loaderdev net (without = because it gave me bad character)
> reset
> and again stuck in =>
>
> On Sun, 11 Nov 2018 at 07:59, Jonas Frey <jf at probe-networks.de> wrote:
>
>> Are you stuck at the "=>" Uboot prompt or are able to reach loader>?
>> From loader> it should be pretty straight forward to reinstall junos
>> from a install media.
>>
>> If you are stuck at "=>" then try:
>> boot
>> (should put you into loader>)
>>
>> Or:
>> setenv loaderdev=net
>> reboot
>> (this should try to load via net, however it can take some time untill
>> it works - just be patient)
>>
>> Or:
>> setenv loaderdev usb1:0
>> boot
>> (should force to load from usb1)
>>
>>
>> If you have a 2nd (same) SRX you could also try to do a "snapshort
>> media usb factory" to the USB stick and afterwards insert that stick
>> into the faulty SRX and force it to boot from there.
>>
>>
>>
>> Am Sonntag, den 11.11.2018, 14:43 +0200 schrieb Mohammad Khalil:
>> > Ops , but it did not work either
>> > Nand format failed
>> >
>> > BR,
>> > Mohammad
>> >
>> > On Sun, 11 Nov 2018 at 14:46, Jonas Frey <jf at probe-networks.de>
>> > wrote:
>> > > Hi Mohammad,
>> > >
>> > > thats a typo, its nand_format (note the underscore).
>> > > Am Sonntag, den 11.11.2018, 05:31 -0500 schrieb Mohammad Khalil:
>> > > > => reset
>> > > >
>> > > >
>> > > > U-Boot 1.1.6-JNPR-2.7 (Build time: Nov 26 2013 - 19:04:49)
>> > > >
>> > > > Initializing memory this may take some time...
>> > > > Measured DDR clock 266.62 MHz
>> > > > SRX_100H2 board revision major:1, minor:0, serial #: BZ4214AF1453
>> > > > OCTEON CN5020-SCP pass 1.1, Core clock: 500 MHz, DDR clock: 266
>> > > MHz
>> > > > (532
>> > > > Mhz data rate)
>> > > > DRAM:  2048 MB
>> > > > Starting Memory POST...
>> > > > Checking datalines... OK
>> > > > Checking address lines... OK
>> > > > Checking 512K memory for U-Boot... OK.
>> > > > Running U-Boot CRC Test... OK.
>> > > > Flash:  4 MB
>> > > > USB:   scanning bus for devices... 4 USB Device(s) found
>> > > >        scanning bus for storage devices... Read Error for
>> > > > STMicroelectronics device 0
>> > > > Not intializing this device, disabling autoboot
>> > > > Device may need formatting, please issue command :
>> > > >         <nand_format> at console prompt to format
>> > > > 2 Storage Device(s) found
>> > > > Clearing DRAM........ done
>> > > > BIST check passed.
>> > > > Boot Media: nand-flash usb
>> > > > Net:   pic init done (err = 0)octeth0
>> > > > POST Passed
>> > > > Press SPACE to abort autoboot in 1 seconds
>> > > > => nand-format
>> > > > Unknown command 'nand-format' - try 'help'
>> > > >
>> > > >
>> > > > On Sun, 11 Nov 2018 at 04:17, Muhammad Atif Jauhar <atif.jauhar at g
>> > > mail
>> > > > .com>
>> > > > wrote:
>> > > >
>> > > > >
>> > > > > Hi Khalil,
>> > > > >
>> > > > > Kindly follow below link to recover it.
>> > > > >
>> > > > >
>> > > > > https://forums.juniper.net/t5/SRX-Services-Gateway/Boot-problem
>> > > -of-
>> > > > > UBoot-srx240-having-status-LED-red/td-p/211103
>> > > > >
>> > > > > Regards,
>> > > > >
>> > > > > Muhammad Atif Jauhar
>> > > > > (+966-56-00-04-985)
>> > > > >
>> > > > >
>> > > > > On Sun, Nov 11, 2018 at 11:36 AM Mohammad Khalil <eng.mssk at gmai
>> > > l.co
>> > > > > m>
>> > > > > wrote:
>> > > > >
>> > > > > >
>> > > > > > Hello all
>> > > > > > I have my Juniper SRX 100h stuck in the u-boot mode
>> > > > > > I have tried to download a new image on a USB stick , plugged
>> > > it
>> > > > > > into the
>> > > > > > device and tried to upgrade with no luck
>> > > > > > Looked around but could not find a solution , anyone can help
>> > > > > > please?
>> > > > > >
>> > > > > > BR,
>> > > > > > Mohammad
>> > > > > > _______________________________________________
>> > > > > > juniper-nsp mailing list juniper-nsp at puck.nether.net
>> > > > > > https://puck.nether.net/mailman/listinfo/juniper-nsp
>> > > > > >
>> > > > _______________________________________________
>> > > > juniper-nsp mailing list juniper-nsp at puck.nether.net
>> > > > https://puck.nether.net/mailman/listinfo/juniper-nsp
>> > >
>>
>