[j-nsp] GRE interfaces doesn't show up

[Jeff Meyers]

Hi Jim,

thanks for the quick reply! However, unfortunately that did not do the
job and the interface still doesn't show up, neither with 1g nor 10g for
the bandwidth:

> # show chassis fpc 0
> pic 0 {
>     tunnel-services {
>         bandwidth 10g;
>     }
> }

> # show interfaces gr-0/0/0
> unit 0 {
>     description Tunnel;
>     tunnel {
>         source 1.2.3.4;
>         destination 4.3.2.1;
>     }
> }

> # run show interfaces gr-0/0/0
> error: device gr-0/0/0 not found

Any ideas? :-(


Thanks,
Jeff



Am 29.08.2019 um 12:38 schrieb Jim Alias:
> On DPCs you need to set the bandwidth setting.
>
> set chassis fpc <n> pic <n> tunnel-services bandwidth <10g - 100g>
>
> Be advised that this will burn a 10 gig port for each 10 gigs you assign to tunnel-services.
>
> Regard,
> Clay Haynes
>
> Sent from my iPhone
>
>> On 29 Aug 2019, at 10:50, Jeff Meyers <Jeff.Meyers at gmx.net> wrote:
>>
>> Hi list,
>>
>> I'm trying to setup a GRE tunnel interface on a MX480 with DPCE
>> linecards. I want to use xe-5/4/0 and have therefore configured this
>> interface under 'edit chassis' for tunnel-services. The interface
>> vanishes as expected. I have then configured the interface gr-5/4/0 with
>> unit 0 but is not being created. It's the same behaviour on a secondary
>> MX router so I might be missing something. I am running Junos 13.3
>> respectively 15.1 on the routers I tested this with.
>>
>> I am unable to identify the reason right now, maybe someone from this
>> list can help me with that? Thanks in advance!
>>
>> Best
>> Jeff
>> _______________________________________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/juniper-nsp