[j-nsp] MX SCBE firmware error

[Jim Alias]

See https://kb.juniper.net/InfoCenter/index?page=content&id=KB26889 (requires
a Juniper login). You could be hitting a PR, or the card is physically
damaged.

Also try restarting the CB:

* To ‘reset a Control Board’, for example on an MX480:
* Run the CLI command ‘request chassis cb slot # offline’,
* Wait 30 seconds.
* Then follow with the CLI command ‘request chassis cb slot # online’.

On Thu, Jul 2, 2020 at 8:07 PM john doe <johan.borch at gmail.com> wrote:

> No it's an older card, but I can't find firmware requirements anywhere.
>
> Johan
>
> On Thu, Jul 2, 2020 at 3:13 PM Jared Mauch <jared at puck.nether.net> wrote:
>
> > Is this a newer one?  I’ve seen vendors release revised boards that have
> > the same part number but require newer software.
> >
> > - Jared
> >
> > > On Jul 2, 2020, at 8:19 AM, john doe <johan.borch at gmail.com> wrote:
> > >
> > > Hi
> > >
> > > I just started up an SCBE we had on the shelf, has anyone seen this
> error
> > > before?
> > >
> > > Major CB 0 SG2P Revision unsupported
> > >
> > > CB 0             REV 20   750-031391    Enhanced MX SCB
> > >
> > > Isn't the firmware usually bundled with software upgrades? Is there a
> > > way to upgrade the SCBE?
> > >
> > > Johan
> > > _______________________________________________
> > > juniper-nsp mailing list juniper-nsp at puck.nether.net
> > > https://puck.nether.net/mailman/listinfo/juniper-nsp
> >
> >
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>