[rbak-nsp] PIM not coming up

[Anton Turygin]

On Thu, 26 Nov 2009, Denis Mikhaylovskiy wrote:

> Hi there!
>
> Are you sure you provide full information here?
> AFAIK by merely issuing   pim sparse-mode on redback side you go with default v2 hello 30 sec.
> But I see hello interval 10 sec in show pim interface output.
>

Hi,

The issue was resolved by restarting the pim process.

Thanks.


>
> -------------------------------------------------------------------------------------
> Date: Wed, 25 Nov 2009 13:03:05 +0200 (EET)
> From: Anton Turygin <pa3op at tsua.net>
> To: redback-nsp at puck.nether.net
> Subject: [rbak-nsp] PIM not coming up
> Message-ID: <20091125125553.U42031 at colt.tsua.net>
> Content-Type: TEXT/PLAIN; charset=US-ASCII; format=flowed
>
> Hi,
>
> Trying to comfigure PIM between Cisco and Redback SE400.
>
> Cisco config:
>
> ip multicast-routing
>
> interface XXX
>  ip pim sparse-mode
>
>
> Redback config:
>
> interface YYY
>   pim sparse-mode
>
>
>> From the Cisco side I see the neighbor coming up:
> #sh ip pim neighbor
> [...]
> Y.Y.Y.Y      XXX                 22:23:16/00:00:30 v2    1 / DR S
>
> But from the Redback side:
> #show pim neighbor
> #
> #show pim interface
> * - Interface running in passive-mode
> Address         Interface           Mode    Cct   Up Nbr   Hello DR
>                                             Count Dn Count Intvl
> Y.Y.Y.Y            YYY            sparse  1    Up 0     10    Y.Y.Y.Y
> #
> #show process pim
>
> NAME           PID    SPAWN    MEMORY  TIME            %CPU  STATE
> UP/DOWN
> pim           4286        1     6044K  00:02:16.80    0.00%  run
> 6d20h
> #
>
> Did I forget something in my configuration? What could be the problem?
>
> Thanks.
>
> --
> RAZ-UANIC
> RAZ-RIPE
>
>
>

-- 
RAZ-UANIC
RAZ-RIPE
Technological Systems CJSC
Senior Network Engineer