[rbak-nsp] PIM not coming up

[Denis Mikhaylovskiy]

Hi there!

Are you sure you provide full information here?
AFAIK by merely issuing   pim sparse-mode on redback side you go with default v2 hello 30 sec.
But I see hello interval 10 sec in show pim interface output.


HIH


-------------------------------------------------------------------------------------
Date: Wed, 25 Nov 2009 13:03:05 +0200 (EET)
From: Anton Turygin <pa3op at tsua.net>
To: redback-nsp at puck.nether.net
Subject: [rbak-nsp] PIM not coming up
Message-ID: <20091125125553.U42031 at colt.tsua.net>
Content-Type: TEXT/PLAIN; charset=US-ASCII; format=flowed

Hi,

Trying to comfigure PIM between Cisco and Redback SE400.

Cisco config:

ip multicast-routing

interface XXX
  ip pim sparse-mode


Redback config:

interface YYY
   pim sparse-mode


>From the Cisco side I see the neighbor coming up:
#sh ip pim neighbor
[...]
Y.Y.Y.Y      XXX                 22:23:16/00:00:30 v2    1 / DR S

But from the Redback side:
#show pim neighbor
#
#show pim interface
* - Interface running in passive-mode
Address         Interface           Mode    Cct   Up Nbr   Hello DR
                                             Count Dn Count Intvl
Y.Y.Y.Y            YYY            sparse  1    Up 0     10    Y.Y.Y.Y
#
#show process pim

NAME           PID    SPAWN    MEMORY  TIME            %CPU  STATE
UP/DOWN
pim           4286        1     6044K  00:02:16.80    0.00%  run
6d20h
#

Did I forget something in my configuration? What could be the problem?

Thanks.

--
RAZ-UANIC
RAZ-RIPE


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/redback-nsp/attachments/20091126/2f57aeb5/attachment.html>