[rbak-nsp] Telnet/SSH problem in SE800

[Mark Loveley]

On 18 January 2011 05:17, Navin Nepali <navin_n at yahoo.com> wrote:

> From management port 7/1 also i can't telnet/ssh.
>
>

Is the client enabled? From the context that your management port is bound
into run "show service", you will see output like this:-

[management]SE400#sh service
Context Services:
         auto-system-recovery    enabled
         card-auto-reload        enabled
         console-break           disabled
         crash-dump-dram         enabled
         domain-wildcard         disabled
         inter-context routing   enabled
         multiple-contexts       enabled
         upload-coredump         disabled
         vxworks-log-to-screen   enabled


Protocol Services:

         Protocol             Client               Server
         -------------------------------------------------------
         ftp                  Enabled              Not Supported
         tftp                 Disabled             Disabled
         sftp                 Disabled             Disabled
         scp                  Enabled              Enabled
         ssh                  Enabled              Enabled
         rcp                  Disabled             Not Supported
         telnet               Disabled             Disabled


[management]SE400#

To enable the clients do this:-
conf
context foo
service telnet client
service ssh client
end
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/redback-nsp/attachments/20110118/789acc5a/attachment.html>