[rbak-nsp] SE600 cold start and a few questions

[Marcin Kuczera]

Hello,

first startup of new SE600 and I have a few questions:

1. Power supply cables - what diameters are normally connected there ?
Original connector are for 35mm2 cables (have no Idea about AWG) - 
cables for about 120A like for electric chair... Max for this device is 
62-63A so 10mm2 cables should be absolutly enough..
The only explanation for me is that this is the same connector as for SE1200

2. default slot for XCRP4 processor - 7 or 8 ?
We have just one and alarms sais:
Jan 31 22:48:58 xcrp4-base        7              Major     Backup fail: 
peer dead
Jan 31 22:48:58 xcrp4-base        8              Critical  Controller 
missing
Jan 31 22:49:08 xcrp4-base        8              Major     Controller 
auto switch completed


seems like slot 8 is default master while slot 7 is default backup.


3. How to switch SEOS into single XCRP mode ? Does it make any sense ?

4. Alarm card POD fail ???
Jan 31 22:48:58 chassis                          Minor     Alarm card 
power-on diagnostic failed

Strange or normal at cold start ?

Regards,
Marcin














[local]SE600-GZE#show system alarm all
Timestamp       Type              Source         Severity  Description
---------------------------------------------------------------------------
Jan 31 22:49:07 chassis                          Minor     Chassis power 
failure
  - side B
Jan 31 22:48:58 chassis                          Minor     Alarm card 
power-on diagnostic failed
Jan 31 22:55:52 10ge-4-port       1/1            Major     Link down
Jan 31 22:55:52 10ge-4-port       1/2            Major     Link down
Jan 31 22:48:58 xcrp4-base        7              Major     Backup fail: 
peer dead
Jan 31 22:48:58 xcrp4-base        8              Critical  Controller 
missing
Jan 31 22:49:08 xcrp4-base        8              Major     Controller 
auto switch completed

[local]SE600-GZE#