[rbak-nsp] Memory upgrade on GE- card

[Marcin Kuczera]

Mulindwa wrote:
> Dear All,
> 
> Am trying to upgrade memory on the gigaether-4-port card, however , 
> after putting memory on board, card does not come up.
> 
> IS there a pattern of putting the memory chips on the card.


I suppose that this memory must be properly branded (in EEPROM).
I know a company that can make any copy of memory, but it is in Poland..

Regards,
Marcin


> 
> Show hardware
> 
>     * 4    gigaether-4-port     8K505040502560  50   4 12-MAY-2005
>       N/A      N/A 
> 
> sh hardware card 4 detail
> 
> Slot              : 4                Type              : gigaether-4-port
> Serial No         : 8K505040502560   Hardware Rev      : 50             
> EEPROM id/ver     : 0x5a/4           Mfg Date          : 12-MAY-2005    
> SysFpga rev       : 0x0              SysFpga file rev  : N/A            
> LimFpga rev       : 0x0              LimFpga file rev  : N/A            
> FlipFpga rev      : 0x0              FlipFpga file rev : N/A            
> IPPA memory       : N/A              EPPA memory       : N/A            
> Voltage           : N/A              Temperature       : N/A             
> Card Status       : HW failure       POD Status        : Fail           
> Card State        : PPA download failure
> ODD Status        : Not 
> Available                                              
> Fail LED          : N/A              Active LED        : N/A            
> Standby LED       : N/A             
> Chass Entitlement : SE400/SE800     
> Ports Entitled    : All             
> Active Alarms     : Circuit pack power-on diagnostic failed
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> redback-nsp mailing list
> redback-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/redback-nsp