[rbak-nsp] SM240 vs SE600 hardware

[Voigt, Thomas]

Hi Marcin,

as requested here is the (anonymized) output from SM240 for you:

###################################################################################
[local]t-002#show mem
Memory: Total 7453844k, Used 419956k, Free 6910096k, Reserved 24k
[local]t-002#show chassis
Current platform is SM240
 (Flags:
    A-Active Route Processor  B-Standby Route Processor
    D-Default Traffic Card    E-EPPA Ready              G-Upgrading FPGA
    H-Card Admin State SHUT   I-IPPA Ready              M-FPGA Upgrade Required
                              O-Card Admin State ODD    R-Traffic Card Ready
    S-SPPA Ready              U-Card PPAs               W-Warm Reboot
    X-SMRP mismatch)
Slot: Configured-type           Slot: Installed-type          Initialized Flags
-------------------------------------------------------------------------------
  1 : fege-60-2-port-sm           1 : fege-60-2-port-sm         Yes IEUR
  2 : none                        2 : none                      No
  3 : none                        3 : none                      No
  4 : none                        4 : none                      No
  5 : none                        5 : none                      No
  6 : ge4-20-port-sm              6 : ge4-20-port-sm            Yes IEUDR
  7 : smrp2                       7 : smrp2                     Yes B
  8 : smrp2                       8 : smrp2                     Yes A
[local]t-002#show hardware card 8 detail

Slot                : 8                 Type                : smrp2 - T1/E1
Serial No           : XXXXXXXXXXXXX     Hardware Rev        : 03 -
EEPROM id/ver       : 0x5a/4            Mfg Date            : XX-XXX-2010
HubFPGA Ver         : 0x1e              SysFPGA Ver         : 0x5
SysCPLD Ver         : 0x4
Voltage 1.200V BCM  : 1.186 (-1%)       Voltage 1.200V GEN  : 1.186 (-1%)
Voltage 1.300V      : 1.289 (-1%)       Voltage 1.800V      : 1.782 (-1%)
Voltage 2.500V      : 2.480 (-1%)       Voltage 3.300V      : 3.305 (+0%)
Voltage 12.000V     : 11.909 (-1%)
Voltage 0.900V AIN1 : 0.893 (-1%)       Voltage 1.500V AIN2 : 1.501 (+0%)
Temp.- Inlet Air    : NORMAL (31 C)     Temp.- Exhaust Air  : NORMAL (35 C)
Temp.- Processor    : NORMAL (42 C)
POD Status          : Success           ODD Status          : Not Available
Fail LED            : Off               Active LED          : On
Standby LED         : Off               Sync LED            : Off
Memory              : Max
Chass Entitlement   : All (0x0)
Active Alarms       : NONE

[local]t-002#show hardware card 1 detail

Slot                : 1                 Type                : fege-60-2-port-sm
Serial No           : XXXXXXXXXXXXX     Hardware Rev        : 02
EEPROM id/ver       : 0x5a/4            Mfg Date            : XX-XXX-2010
HubFpga rev         : 0xd               HubFpga file rev    : 0xe
DimFpga rev         : 0xd1              DimFpga file rev    : 0xd1
IPPA memory         : 1024 MB           EPPA memory         : 1024 MB
Voltage 1.000V      : 0.991 (-1%)       Voltage 1.200V      : 1.196 (-0%)
Voltage 1.800V      : 1.792 (-0%)       Voltage 2.500V      : 2.490 (-0%)
Voltage 2.600V      : 2.588 (-0%)       Voltage 3.300V      : 3.286 (-0%)
Temperature         : NORMAL (43 C)
Card Status         : HW initialized    POD Status          : Success
ODD Status          : Not Available
Fail LED            : Off               Active LED          : On
Standby LED         : Invalid
Chass Entitlement   : All (0x0)
Ports Entitled      : All
Active Alarms       : NONE

[local]t-002#show version

Redback Networks SmartEdge OS Version SEOS-6.4.1.2-Release
Built by sysbuild at SWB-node04 Wed Dec 22 08:17:27 PST 2010
Copyright (C) 1998-2010, Redback Networks Inc. All rights reserved.
System Bootstrap version is Mips,rev2.0.2.45
Installed minikernel version is 11.7
Router Up Time -   757 days, 23 hours 49 minutes 18 secs
###################################################################################

Hope this helps.

-- 
Regards
 
Thomas Voigt