[rbak-nsp] SM240 vs SE600 hardware

Marcin Kuczera marcin at leon.pl
Wed Jul 3 08:22:07 EDT 2013


On 2013-07-03 14:12, Voigt, Thomas wrote:
> Hi Marcin,
>
> as requested here is the (anonymized) output from SM240 for you:

Great, SEOS looks the same.
You probably have PPA2 linecards inside - with 1G Ram per PPA.
In PPA3 there is 2G per PPA.

It seems that if one modifies EEPROM in chassis + route-processor and 
linecards - then should get SE600 system instead ;)
Processor has 8G RAM on board, that's same as for XCRP4.

Regards,
Marcin


>
> ###################################################################################
> [local]t-002#show mem
> Memory: Total 7453844k, Used 419956k, Free 6910096k, Reserved 24k
> [local]t-002#show chassis
> Current platform is SM240
>   (Flags:
>      A-Active Route Processor  B-Standby Route Processor
>      D-Default Traffic Card    E-EPPA Ready              G-Upgrading FPGA
>      H-Card Admin State SHUT   I-IPPA Ready              M-FPGA Upgrade Required
>                                O-Card Admin State ODD    R-Traffic Card Ready
>      S-SPPA Ready              U-Card PPAs               W-Warm Reboot
>      X-SMRP mismatch)
> Slot: Configured-type           Slot: Installed-type          Initialized Flags
> -------------------------------------------------------------------------------
>    1 : fege-60-2-port-sm           1 : fege-60-2-port-sm         Yes IEUR
>    2 : none                        2 : none                      No
>    3 : none                        3 : none                      No
>    4 : none                        4 : none                      No
>    5 : none                        5 : none                      No
>    6 : ge4-20-port-sm              6 : ge4-20-port-sm            Yes IEUDR
>    7 : smrp2                       7 : smrp2                     Yes B
>    8 : smrp2                       8 : smrp2                     Yes A
> [local]t-002#show hardware card 8 detail
>
> Slot                : 8                 Type                : smrp2 - T1/E1
> Serial No           : XXXXXXXXXXXXX     Hardware Rev        : 03 -
> EEPROM id/ver       : 0x5a/4            Mfg Date            : XX-XXX-2010
> HubFPGA Ver         : 0x1e              SysFPGA Ver         : 0x5
> SysCPLD Ver         : 0x4
> Voltage 1.200V BCM  : 1.186 (-1%)       Voltage 1.200V GEN  : 1.186 (-1%)
> Voltage 1.300V      : 1.289 (-1%)       Voltage 1.800V      : 1.782 (-1%)
> Voltage 2.500V      : 2.480 (-1%)       Voltage 3.300V      : 3.305 (+0%)
> Voltage 12.000V     : 11.909 (-1%)
> Voltage 0.900V AIN1 : 0.893 (-1%)       Voltage 1.500V AIN2 : 1.501 (+0%)
> Temp.- Inlet Air    : NORMAL (31 C)     Temp.- Exhaust Air  : NORMAL (35 C)
> Temp.- Processor    : NORMAL (42 C)
> POD Status          : Success           ODD Status          : Not Available
> Fail LED            : Off               Active LED          : On
> Standby LED         : Off               Sync LED            : Off
> Memory              : Max
> Chass Entitlement   : All (0x0)
> Active Alarms       : NONE
>
> [local]t-002#show hardware card 1 detail
>
> Slot                : 1                 Type                : fege-60-2-port-sm
> Serial No           : XXXXXXXXXXXXX     Hardware Rev        : 02
> EEPROM id/ver       : 0x5a/4            Mfg Date            : XX-XXX-2010
> HubFpga rev         : 0xd               HubFpga file rev    : 0xe
> DimFpga rev         : 0xd1              DimFpga file rev    : 0xd1
> IPPA memory         : 1024 MB           EPPA memory         : 1024 MB
> Voltage 1.000V      : 0.991 (-1%)       Voltage 1.200V      : 1.196 (-0%)
> Voltage 1.800V      : 1.792 (-0%)       Voltage 2.500V      : 2.490 (-0%)
> Voltage 2.600V      : 2.588 (-0%)       Voltage 3.300V      : 3.286 (-0%)
> Temperature         : NORMAL (43 C)
> Card Status         : HW initialized    POD Status          : Success
> ODD Status          : Not Available
> Fail LED            : Off               Active LED          : On
> Standby LED         : Invalid
> Chass Entitlement   : All (0x0)
> Ports Entitled      : All
> Active Alarms       : NONE
>
> [local]t-002#show version
>
> Redback Networks SmartEdge OS Version SEOS-6.4.1.2-Release
> Built by sysbuild at SWB-node04 Wed Dec 22 08:17:27 PST 2010
> Copyright (C) 1998-2010, Redback Networks Inc. All rights reserved.
> System Bootstrap version is Mips,rev2.0.2.45
> Installed minikernel version is 11.7
> Router Up Time -   757 days, 23 hours 49 minutes 18 secs
> ###################################################################################
>
> Hope this helps.
>



More information about the redback-nsp mailing list