[rbak-nsp] Clips and DHCP relay problem

[Rafal]

Hello Thomas,

Still same error with dhcp proxy on interface
Oct 13 13:33:20: [0515]: [2/9:511:63:31/7/2/280443]: %AAA-3-ERR: aaa_idx 50125966: aaa_update_dhcp_sub_circuit: session 2/9:511:63:31/7/2/280443 isn't configured for DHCP sessio
n_class 1 dhcp_max_addr max_addr 0

While  session  is authenticated for short moment I see something like
this:


sh subscribers active


11:63:59:87:ce:10
        Session state Up
        Circuit   2/9 vlan-id 2009 clips 419841
        Internal Circuit   2/9:511:63:31/7/2/280279
        Interface bound  evstb0
        Current port-limit unlimited
        Protocol Stack IPV4
        dhcp max-addrs 1 (not applied)
        ip address 178.214.1.3 (applied)
        dhcp vendor class id udhcp [JR_1]1.20.2 (applied)
        dhcp option client id 0x3d070168635987ce10 (applied)
        qos rate outbound rate 8991 burst 1684500 (applied)
        qos rate inbound rate 8991 burst 1684500 (applied)
        qos-metering-policy QOS1POLICY_evio (applied)
        qos-policing-policy QOS1OUT_evio (applied)
        forward policy in NORMALPOLICY_evio (applied)
        ip multicast send permit (applied from sub_default)
        ip multicast receive permit (applied from sub_default)
        timeout idle 21600 (applied from sub_default)
        qos-queuing-policy 128SharedUserRx (applied from sub_default)


After  like  1-2 sec session is killed with error in log.
Also dhcp max-addrs 1 (not applied) seems strange.

Is there anything more I should check ?

Rafal


Tuesday, October 13, 2015, 1:20:33 PM, you wrote:

> Hi Rafal,

> you wrote:

>> I  want  to run Clips service with separate dhcp server (SEOS built in doesn't
>> provide options I need).
>> 
>> My config looks like this
>> 
>> #############
>> context ev
>> !
>>  no ip domain-lookup
>> !
>>  interface evstb0 multibind
>>   ip address 178.214.1.1/27
>>   dhcp relay 65535

> Try to use "dhcp proxy ..." instead of "dhcp relay ..." inside the
> multibind interface configuration.

> The documentation says for "dhcp proxy" and "dhcp relay":

> "These commands are mutually exclusive. If you are configuring
> CLIPS, you must use the dhcp proxy command."

> --
> regards
> Thomas
> _______________________________________________
> redback-nsp mailing list
> redback-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/redback-nsp



-- 
Best regards,
Ozga Rafal                          mailto:golem at mtm-info.pl